[Limdep Nlogit List] FW: Limdep project setting

[David Hensher]

You have to go to projects/settings/data area and change and then 
save  and get out of nlogit and start again and it will stay at the 
area you typed in.

The only way this could change in time back to the default is that 
you did not save it by pressing OK.

David Hensher
At 02:43 PM 2/05/2010, Yen, Steven T wrote:
>Hi
>I have a problem which occurred after re-installing Windows and 
>NLOGIT4. In the past, I had been able to set the "data area" to 
>handle the number of cells I need (e.g., 20000000, which required 
>about 152 MBytes of memory). This was a on-time operation, meaning 
>once I set the project settings, it stayed that way until another reset.
>After my Windows/NLOGIT re-installation, the project setting returns 
>to 200000 cells after a NLOGIT session, and I have had to fix the 
>setting each time I run NLOGIT. I tested this with NLOGIT3 and it 
>did the same thing, which made me think that it is my system and not 
>NLOGIT that's doing this. Any clue? Thanks.
>Steven Yen
>
>_______________________________________________
>Limdep site list
>Limdep at limdep.itls.usyd.edu.au
>http://limdep.itls.usyd.edu.au