[Limdep Nlogit List] FW: Limdep project setting

[Steven Yen]

Thanks. I found --

Tool/Options/Projects did it.

Projects/settings/data area did not (a temporary change).

At 01:39 AM 5/2/2010, you wrote:
>You have to go to projects/settings/data area and change and then
>save  and get out of nlogit and start again and it will stay at the
>area you typed in.
>
>The only way this could change in time back to the default is that
>you did not save it by pressing OK.
>
>David Hensher
>At 02:43 PM 2/05/2010, Yen, Steven T wrote:
> >Hi
> >I have a problem which occurred after re-installing Windows and
> >NLOGIT4. In the past, I had been able to set the "data area" to
> >handle the number of cells I need (e.g., 20000000, which required
> >about 152 MBytes of memory). This was a on-time operation, meaning
> >once I set the project settings, it stayed that way until another reset.
> >After my Windows/NLOGIT re-installation, the project setting returns
> >to 200000 cells after a NLOGIT session, and I have had to fix the
> >setting each time I run NLOGIT. I tested this with NLOGIT3 and it
> >did the same thing, which made me think that it is my system and not
> >NLOGIT that's doing this. Any clue? Thanks.
> >Steven Yen
> >
> >_______________________________________________
> >Limdep site list
> >Limdep at limdep.itls.usyd.edu.au
> >http://limdep.itls.usyd.edu.au
>
>
>_______________________________________________
>Limdep site list
>Limdep at limdep.itls.usyd.edu.au
>http://limdep.itls.usyd.edu.au


Steven T. Yen
http://web.utk.edu/~syen/
Check out our postdoc opening at:
http://web.utk.edu/~syen/postdoc.html