[Limdep Nlogit List] (Mprobit)

[Robert Iquiapaza]

Try a code similar to:

MPROBIT ; LHS = Y1, Y2,Y3 ; MarginalEffects
        ; Eq1 = One,x...
        ; Eq2 = One,x...
        ; Eq3 = One,x..

good luck



--------------------------------------------------
From: "Sharmistha Nag" <nags at onid.orst.edu>
Sent: Wednesday, May 27, 2009 10:50 PM
To: "limdep" <limdep at limdep.itls.usyd.edu.au>
Subject: [Limdep Nlogit List] (no subject)

> I am running a logit model with 5 sets of equations. I am using the  
> following code:
> logit; lhs= y1, y2,y3, y4,y5;
> rh1= x1, x2, x3, x4, x5;marginal;
> rh2= x1, x2, x3, x4, x5;marginal;
> rh3= x1, x2, x3, x4, x5;marginal;
> rh4= x1, x2, x3, x4, x5;marginal;
> rh5= x1, x2, x3, x4, x5;marginal$
> 
> When I run this I get the estimates for the 1st model only (i.e. for y1).
> I guess Simultaneous equation models in limdep are run using the above  
> code, so I tried using it in a logit framework. But it doesn't work.I  
> would appreciate if somebody could point out the mistake.
> Thank You.
> 
> Sharmistha Nag
> Dept of Agricultural & Resource Economics
> OREGON ST UNIV
> 
> 
> 
> 
> _______________________________________________
> Limdep site list
> Limdep at limdep.itls.usyd.edu.au
> http://limdep.itls.usyd.edu.au
>